Description
Super Sprouter: Aqua Clone
The Super Sprouter: Aqua Clone’s 24 site cloner works on the principle of recirculating super oxygen-rich water created by the Aqua Clone aeration pump. No spray jets to clog up. The Aqua Clone aeration pump draws in oxygen from the atmosphere and produces turbulence to continuously nourish your cuttings. Aqua Clone has integrated finger cut outs in the lid to easily remove neoprene inserts. Easy lift handles built into the lid, allowing you to look for roots with ease. Reservoir is slightly elevated for water temperature control. Also includes 30 colored neoprene inserts, giving you six extra inserts.
Instructions:
- Moisten suction cups. Position aeration pump on the end of the tub that has the Cord Hole Notch. Place pump in the center of the inset panel and rest the pickup screen on the bottom of the tub.
- Place the Power Cord and Air Line from the pump through the Cord Hole Notch in the tub. Air flow can be adjusted by using the valve at the end of the air line (opening the valve completely is recommended).
- Place tub on flat, level surface. Fill with water just to the top of the pump. This allows about 13/4″ to 2″ of space between water surface and bottom of the neoprene inserts.
- Align the notch in the lid with the notch in the tub and place the lid on the tub. Place cuttings in neoprene inserts with 11/2″ to 13/4″ of prepared stem protruding below the insert. Make sure there are 1-2 “nodes” on each stem.
- OPERATION: After inserting cuttings, plug the power cord in a 120 Volt AC outlet. No need for a timer, your pump runs continuously.
For more information, check out the official Super Sprouter website!
Check out the Super Sprouter Micro Greenhouse Kit!
